Reconnect battery terminal Insert key into ignition (dont start the engine) Press down on the brake peddle and hold it there press the epb button twice (once, count to three then again) take foot off the brake. All sounds great but i'll put this into practice tonight and repost back on how it works. When found in VW Passat (3C): Parking Brake: Clear Fault Codes with Engine running (to ensure proper Voltage Supply). When checking Voltage with this Fault Code stored, the Module may not output Power to the Motor. Try clearing Fault Codes and Operating the EPB as mentioned below before testing again. 02432 - Supply Voltage for Left Parking Brake Motor (V282): Open Circuit Possible Symptoms. Parking Brake Warning Light active/flashing; Possible Causes. Wiring/Connectors from/to Left Parking Brake Motor (V282) faulty; Left Parking Brake Motor (V282) Power Supply faulty; Left Parking Brake Motor/Caliper (V282) faulty; Possible Solutions I took the car to the mechanic today and the "believe" based on the codes in VAGCOM that it's the parking brake control module. I would hate to spend (roughly) $2000 to change this out with out certainty and find it was only a fault Parking switch. The light on the dash was on and the brake would have trouble engaging or disengaging (working intermittently). Through research I found two of the highest possibilities: 1. Parking brake switch failure. 2. Brake control module. I ordered a new parking brake switch for $15, replaced and all works fine again. orivers66. LswxKgR.